Operator Manual
Cha
pt
er
:
Op
era
to
r i
nt
erf
ac
e
16
Operator interface
Controls and signals
1) Stereo microscope.
2) Inspection window with filter for LASER beams at 1064 nm.
3) Hands entrance.
4) Touch-screen display for setting welding parameters.
5) Rear connections (see “Rear Connections” paragraph).
6)
Liquid cooling system; do not cover the vent, leave at least
5 cm between the vent and the wall.
7)
Coolant level, for correct efficiency of the equipment: the
level MUST always be at maximum mark. Use double-
distilled water only for top-up/replacement.
8)
Compartment for extraction of the liquid top-up pipes.
Rear connections
1) Resettable fuses.
2) Power supply socket.
3) Master switch.
4) Protection Air/GAS inlet.
5) Compressed air inlet, if envisioned.
6) Control pedal.
7) Interlock remote connection (see paragraph).
8) Composite video output (for OBC models only).
If present, the composite video connection is the analogue PAL type (75 Ω 1Vpp).
WARNING!
Always refer to the operating voltage indicated near to the power supply outlet. Check the electric conditions before connecting the
equipment.
1
2
3
4
5
6
7
1
2
3
4
5
6
7
8
8
