Oregon Scientific SE233, Руководство пользователя

Страница: 9 / 368

8
EN
GETTING STARTED
UNPACKING THE WATCH
When you unpack your VIBRA Trainer Elite / VIBRA Trainer Elite
Pro watch, make sure to keep all the packing materials in a safe
place, in case you need to later transport or return the product for
servicing.
In this box, you will find:
• Watch
• Heart rate chest belt
• Mounting bracket
• Carry case
• 2 x CR2032 lithium batteries - already installed
TURNING ON THE WATCH (FIRST-TIME USE ONLY)
Press any key for 2 seconds to activate the LCD display.
BATTERIES
The VIBRA Trainer Elite / VIBRA Trainer Elite Pro uses two CR2032
lithium batteries, one for the watch and another for the heart rate
chest belt. Both are already installed. See the table below for
battery warnings.
LOW BATTERY ICON DESCRIPTION
The battery is too low to run the
backlight
The battery is too low to run the
vibration alert
The batteries typically last one year. We highly recommend that
you contact the retailer or our customer service department if you
need to replace them.
The watch battery is low; the
vibration alert and backlight cannot
be used
The chest belt battery is nearly too
low to send a signal to the watch
SE212 English R7 OP_OK.p65 2006.1.6, 1:53 AM 8
P/N: 086L004247-012 REV1
9/314
9
EN
To replace the watch battery:
1. Turn the watch over so that you are looking at the back plate.
2. Disconnect the watchstrap as shown above.
3. Using a small screwdriver, remove the four screws that hold
the back plate into position.
4. Remove the back plate and set it aside.
5. Using a thin blunt instrument, hook the release catch and lift
the clip.
6. With your finger, remove the old battery and set it aside.
7. Slide the new battery into the battery compartment with the
+
side upwards.
8. Replace the battery clip.
9. Replace the back plate and screws.
SE212 English R7 OP_OK.p65 2006.1.6, 1:53 AM 9
P/N: 086L004247-012 REV1
10/314