Oracle SPARC Enterprise M4000, Инструкция по установке и обслуживанию

Страница: 117 / 182

Chapter 4 Servicing and Replacing Components 4-21
Caution – If the carrier handle does not close easily, the PCI card might not be
seating properly in the card socket in the I/O boat. Remove the carrier and inspect
the PCI card. If the bottom of the PCI card is not perfectly horizontal, loosen the card
locks and realign the card on the carrier. For troubleshooting information, see
Appendix D .
e. Lock the carrier handle into place with the carrier locking screw located on
the top of the handle.
13. Move PCI cards and carriers from slots 1 through 6 in the old I/O boat to the
new I/O boat.
See Step 11 and Step 12 above for instructions to safely remove and insert carriers.
14. Attach the I/O cables to the PCI cards.
15. Move the cable plate back into the normal position (
FIGURE 4-4
) and tighten the
cable plate locking screw(s).
16. Connect the link cable or cables between the link card in the host server and the
link card in the I/O boat.
17. Turn on the AC switches on the External I/O Expansion Unit PSUs.
On the PSUs the AC power ( ) and DC power ( ) LEDs should light.
For other LED indications, see Appendix B .
18. Power up the link.
See Section 4.13, “Powering Up a Link After Service” on page 4-33 .
4.11.2 Replacing a Boat in a Dual Boat Configuration
1. If the I/O boat is still operating, power down the link.
See Section 4.4, “Powering Down a Link Before Service” on page 4-6 .
2. Use an antistatic strap for this procedure.
3. Move the cable plate to the service position:
a. Loosen the cable plate locking screw(s) (item 3 in
FIGURE 4-4
).
b. Pull the cable plate toward you approximately 0.5 in./13 mm, then raise it
approximately 0.75 in./20 mm, until the bottom of the plate is above the tops
of the support brackets.