Optoma LS200, Руководство пользователя, Страница: 50 / 106

© Optoma
Issue 2.1 July 25, 2018
50
used but detail loss may occur in dark areas. If too high a setting is chosen, image solarization may be
observed where dark image areas turn completely black or even change colour.
Settings: 0 to 255 in steps of 1
Default:
0
6.2.3 Output Config
6.2.3.1 HDMI & DVI Outputs
Internally, the output interface processes data at a full ten bits per colour. The colour depth on the
HDMI outputs is determined by the supported standard of the attached monitor or device when set to
DVI/HDMI.
DVI 1.0 and HDMI 1.1/1.2 devices are set at 24 bit, for HDMI 1.3 or later compliant devices it is up to 36
bit. The DVI forced selection will output video with 24 bit colour depth irrespective of the supported
standard of the attached monitor.
Settings: DVI forced, DVI/HDMI, HDMI 8-bit, 10bit, 12-bit
Default:
HDMI
6.2.3.2 HDCP
HDCP encryption support on the output can be switched off as is in the input. This means the unit
pretends to be non-HDCP compliant on the DVI/HDMI output port and consequently does not encrypt
data.
At the same time, HDCP is also turned off at the input ports. This allows the unit to accept non-HDCP
encrypted data. If the source however, is HDCP encrypted, then the output will be black.
Settings: On, Off
Default:
On