
© Optoma
Issue 2.1 July 25, 2018
46
6.2
Output
This menu contains adjustments related with the outputs of the unit.
6.2.1
Display Type
6.2.1.1
Output Mode (Resolution)
The selected output resolution should match the native resolution of the imaging device to avoid
double scaling. When you are connected to an LED display, choose a resolution that is equal or
greater than the display resolution. Then use the LED screen size adjustment to accurately scale to the
LED wall. Some low-cost LED walls display artefacts when using lower resolution settings. To deal with
these artefacts it is sometimes necessary to choose a much higher resolution, and then use the LED
screen size adjustment as described above.
The 3GSDI output does not feature the PC resolutions; only 480i, 576i, 720p and 1080i/p output
modes are supported.
Settings:
See the Supported format table in the Product Specification chapter
Default:
1920x1080p
6.2.1.2
Frame Rate
As with the output resolution, the output frame rate should match the native frame of the imaging
device. Some frame rates may not be available depending on the selected resolution.
In auto mode, the output frame rate follows the input frame rate if it supported by the output
resolution. If the input frame rate is not supported by the output resolution, then the unit determines
the output frame according to a procedure programmed in the software.
Settings:
60 Hz, 59.94 Hz, 50 Hz, 48 Hz, 25Hz, 24 Hz, 23.97, Auto
Default:
59.94Hz
Содержание LS200
Страница 1: ...PS200 PS200T PS300T LS200 LS200T LS300T 4K Scalers Switchers User s Manual...
Страница 2: ...Optoma Issue 2 1 July 25 2018 2 This page is intentionally left blank...
Страница 105: ...Optoma Issue 2 1 July 25 2018 105 APPENDIX D Unit Dimensions...
Страница 106: ...Optoma Issue 2 1 July 25 2018 106...