Optimum Optimum 3292385, Руководство по эксплуатации, Страница: 41 / 80

Maintenance
Version 1.0.4 - 2020-10-13 41 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_6.
fm
5 Maintenance
In this chapter you will find important information about

Inspection

Maintenance

Repair
of the metal band saw.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the metal band saw and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
Make sure that the coolant lubricants and oils are not split on the floor.
Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current environmental protection regulations.
Collect leakages
Do not re-introduce liquids spilt outside the system during repair or as a result of leakage from
the reserve tank; collect them in a collecting container for disposal.
Disposal
Never dump oil or other environmentally hazardous substances which are harmful to the env-
ironment in water inlets, rivers or channels.
Used oils must be delivered to a collection centre. Please consult your supervisor for further
information on your nearest collection point.
5.1 Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:

extremely serious injuries to those working on the metal band saw and

damage to the metal band saw.
Only qualified staff should carry out maintenance and repair work on the metal band
saw.
Use the prescribed protective equipment.
5.1.1 Preparation
WARNING!
Only carry out work on the metal band saw if it has been disconnected from the mains
power supply.

Disconnecting and securing the metal belt saw on page 14. Attach a warning label.
5.1.2 Restarting
Before restarting, run a safety check.

Safety check on page 12