Optimum Optimum 3292385, Руководство по эксплуатации, Страница: 24 / 80

Version 1.0.4 - 2020-10-13 24 Translation of original instruction
SD500AV
EN
SD500A
V_G
B
_3.
fm
3.2.6 Material stop

Insert the guide rod into
the location hole.

Clamp the motion rod with
the front clamp screw.

Mount the material stop
on the limit stop fixture
and clamp it using the
clamping screw.

Adjust the position of the
guide rod in the seat hole
using the scale by means
of the clearance between
the depth stop and the
saw blade.
Fig.3-6: Material stop

Clamp the limit stop fixture with the front clamp screw.
3.2.7 Cleaning and lubricating

Remove the anti-corrosive agents on the metal belt saw which had been applied for trans-
portation and storage. Therefore, we recommend you to use paraffin.

Do not use any solvents, thinner or other cleaning agents which could corrode the varnish
on the metal belt saw. Observe the indications and notes of the manufacturer for cleaning
agents.

Oil all blank machine parts using an acid-free lubricating oil.

Grease the metal belt saw according to the lubrication chart.
3.2.8 Top up hydraulic oil
The metal band saw is delivered without hydraulic oil.

Fill the tank of the hydraulic unit with a standard
hydraulic oil via the filling opening.

Operating material on page 17

„ Refilling hydraulic oil“ on page 47

„ setting the operating pressure“ on page 47

„Recommended operating materials“ auf Seite
48
Fig.3-7: Hydraulic power unit
Clamping screw
front
Material stop
Clamping screw
Limit stop fixture
Clamping screw
Motion road with
scale
Clamping screw
front
Location hole