Optimum Optimum 3292385, Руководство по эксплуатации, Страница: 15 / 80

Safety
Version 1.0.4 - 2020-10-13 15 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_1.
fm
1.13.2 Using lifting equipment
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check that the lifting and load suspension gear has

sufficient load capacity

and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads carefully.
Never walk under suspended loads!
1.13.3 Mechanical maintenance work
Remove or install protection safety devices before starting or after completing any main-
tenance work; this include:

covers,

safety instructions and warning signs,

grounding cables.
If you remove protection or safety devices, refit them immediately after completing the work.
Check that they are working properly!
1.14 Accident report
Inform your supervisors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the quicker the causes can be eliminated.
INFORMATION
We provide information about the dangers of working with and on the metal belt saw in these
work descriptions.
1.15 Electrical system
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Disconnect the metal belt saw immediately if there is a malfunction
in the power supply !
Comply with the required inspection intervals in accordance with the factory safety directive,
operating equipment inspection DGUV, formerly BVG.
The operator of the machine must ensure that the electrical systems and operating equipment
are inspected with regards to their proper condition, namely,

by a qualified electrician or under the supervision and direction of a qualified electrician,
prior to initial commissioning and after modifications or repairs, prior to recommissioning

and at certain intervals.
The deadlines must be set so that arising, foreseeable defects can be detected in a timely man-
ner.
The relevant electro-technical rules must be followed during the inspection.