Optimum Optimum 3292385, Руководство по эксплуатации, Страница: 9 / 80

Safety
Version 1.0.4 - 2020-10-13 9 Translation of original instruction
SD500AV EN
SD500A
V_G
B
_1.
fm

Clamp the workpiece firmly and as vibration-free as possible.

Long workpieces must be supported. Use a suitable support.
1.6 Possible dangers caused by the metal band saw.
The construction and design of the metal band saw are state-of-the-art.
Nevertheless, there is a residual risk as the metal belt saw operates with

electrical voltage and currents and

a circulating metal saw band.
We have used construction resources and safety techniques to minimize the health risk to per-
sonnel resulting from these hazards.
If the metal band saw is used and maintained by personnel who are not duly qualified, there
may be a risk resulting from incorrect or unsuitable maintenance of the metal band saw.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to personnel,

the metal belt saw and further property might be endangered,

the correct function of the metal belt saw may be affected.
Always disconnect the metal belt saw from the electrical power supply when performing
cleaning or maintenance works.
WARNING!
The metal belt saw may only be used with the safety devices activated. Disconnect the
metal belt saw immediately whenever you detect a failure in the safety devices or when
they are not mounted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices. This is your responsibility as the operator!

Safety devices on page 11
1.7 Qualification of personnel
1.7.1 Target group
This manual is addressed to

the operating companies,

the operators,

the maintenance personnel.
Therefore, the warning notes refer to both operation and maintenance of the metal belt saw.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
Disconnect the main plug of the metal belt saw and secure the metal belt saw against restar-
ting.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks performed beyond operation in standard mode