OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.3.0 dated 2016-12-16
Page 72
Original operating instructions
MF2 Vario
GB
8
Appendix
8.1
Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
8.3
Change information operating manual
Term
Explanation
Cross table
Bearing surface, clamping surface for the workpiece with X- and Y-
axis travel
Taper mandrel
Cone of the drill or of the drill chuck
Workpiece
Piece to be milled, drilled or machined.
Draw-in rod
Threaded rod to fix the taper mandrel in the spindle sleeve.
Drill chuck
Drill bit chuck
Collet chuck
Holder for end mill
Drill-Mill head
Upper part of the milling machine
Spindle sleeve
Hollow shaft in which the milling spindle turns.
Milling spindle
Shaft activated by the motor
Drilling table
Supporting surface, clamping surface
Taper mandrel
Cone of the drill or of the drill chuck
Spindle sleeve lever
Manual operation for the drill feed
Quick action -
Drill chuck
Drill chuck can be fixed by hand.
Tool
Milling cutter, drill bit, etc.
Chapter
Short note
new version number
CE
EC declaration
1.2.7
CE
EMC 2014/30/EU & LVD 2014/35/EU
1.2.8
1
Advanced information on inspection obligations
1.2.8
all
DPA 2000 images replaced with DPA21 images
1.2.9
3
Notes on the circuit breaker
1.3.0
