OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.3.0 dated 2016-12-16
Page 16
Original operating instructions
MF2 Vario
GB
1.16
Electrical system
Have the electrical equipment on the machine checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Immediately disconnect the milling machine if there are any anoma-
lies in the power supply!
Comply with the required inspection intervals in accordance with the factory safety directive,
operating equipment inspection.
The operating company responsible for the machine must ensure that the electrical systems
and operating equipment are inspected with regards to their proper condition, namely,
by a qualified electrician or under the supervision and direction of a qualified electrician,
prior to initial start-up and after modifications or repairs, prior to restarting the equipment
and at certain intervals.
The deadlines must be set so that arising, foreseeable defects can be detected in a timely man-
ner.
The relevant electro-technical rules must be followed during the inspection.
The inspection prior to initial operation is not required if the operator receives confirmation from
the manufacturer or installer that the electrical systems and operating equipment comply with
the accident prevention regulations.
Permanently installed electrical systems and operating equipment are considered constantly
monitored if they are continually serviced by qualified electricians and inspected by means of
measurements in the scope of operation (e.g. monitoring the insulation resistance).
1.17
Inspection deadlines
Define and document the inspection deadlines for the machine in accordance with § 3 of the
Factory Safety Act and perform an operational risk analysis in accordance with § 6 of the Work
Safety Act. Also use the inspection intervals in the maintenance section as reference values.
1.18
Clamping devices for workpieces and tools
ATTENTION!
Attention when taking over the existing clamping devices. Pleased check critically if the
clamping device is appropriate for your milling-machine.
Only use clamping devices which have a complete inherent stiffness.
Contact the manufacturer of the clamping device regarding the reuse of the clamping
devices after damages on the clamping devices due to collisions.
Correctly insert the workpiece and make sure that the machine is proper working
condition.
