HiScan Touch
Installation and Operation Manual
OPTIKON 2000
Code 14101XEN
6-1
2014-09-02 Rev.B
6
INSTALLATION
6.1 INTRODUCTION
This section details the recommended procedure to install HiScan.
The operational checks, carried out after the installation of the device to verify its
correct operation, must be carried out exactly as indicated and must never be
considered as recommended practice or encouragement for any diagnostic
procedures.
In order to be able to use the echograph, it is first necessary to connect the cables,
footswitch and probes.
Carefully follow the installation and operation procedure in sequence to be able to
gain the knowledge required to correctly operate the echograph.
6.2 UNPACKING AND INITIAL INSPECTION
The device has been packed to minimise the risk of damage during shipping. Open
the package and examine the components. When opening the package, handle all
the components with care. When cutting the packing material, be careful not to
damage the contents. If the package or contents are damaged, notify the carrier
(post office, railway or shipping agent) and Optikon 2000 as soon as possible. Check
that the contents correspond to those indicated in the attached shipping documents.
Immediately report any discrepancies to Optikon 2000.
Depending on the selected configuration, the package of the A/Bscan HiScan
echograph contains the following standard and optional components:
•
1 echograph
•
1 contact probe, 10 MHz
•
1 contact probe, 20 MHz
•
1 immersion probe, 25 MHz
•
1 immersion probe, 50 MHz
•
1 probe, 12 MHz
•
1 probe, 20 MHz
•
1 probe, 50 MHz (Full configuration only)
•
1 transducer, 25 MHz (Full configuration only)
•
1 transducer, 35 MHz (Full configuration only)
•
1 probe cable
•
1 user manual
•
1 kit of cups for immersion ecography (available in the following sizes: "small",
"medium" and "large")
