LIBRETTO ISTRUZIONI - INSTRUCTION MANUAL
25
EN
19
Problem
Cause
Solution
The remote control does not
work
The batteries of the remote control are
low
Replace the batteries
None of the LEDs on the control
panel are illuminated
Damaged fuses
Turn off the supply of power to the control
panel; check the wiring and replace the
fuse with one of a similar type
None of the LEDs on the control
panel are illuminated
No power to the control panel
Check the differential or magnetothermal
circuit breaker on the power line
The control panel does not enter
programming mode
Safety devices in alarm mode (STOP,
PHC and EDGE)
Check that the diagnostics LEDS STOP,
PHC and EDGE are on; check the device
with the LED off
The gate does not close
PHC input in alarm mode
Check that the diagnostics LED PHC is on;
check the device with the LED off
The gate does not completely
close the stroke
Insufficient force of the motors
Increase the force using the COUPLE
trimmer
Increase the force using the DIRECTION
trimmer
The gate starts and immediately
stops
Starting breakaway not enabled
Bring the dip switch number 2 to the OFF
position (soft start not enabled)
The gate does not stop at the limit
switch
The limit switch does not recognise
the magnet inserted in the bracket
Bring the clamp close to the limit switch
sensor
TROUBLESHOOTING
20
USER MANUAL:
The user manual provided is an integral part of the product and must be read with care, as it contains important instructions on use
and maintenance. This manual must be retained and made available to other future users.
The EC1 control panel was designed to control the operation of 230 VAC sliding gate of ON AUTOMATION – ITALY series CRONO/
TITAN2000.It is forbidden to put the product to any uses other than the intended one. Any other use is considered improper and po-
tentially dangerous. It is forbidden to tamper with or make changes to the product.
Do not allow children to play or stand within the operating radius of the automation. Monitor the motion activation devices in order to
prevent involuntary activation by children or other people.
It is recommended to contact the installation company and prepare a routine maintenance schedule, as required in accordance with the
applicable standards (within the EEC: Machine Directive 2006/42/EEC). Perform correct routine maintenance referring to the mainte-
nance booklet provided by the installer.
Connection, testing and commissioning of the control panel, and all periodic checks and maintenance work, including cleaning of the
drive, must be entrusted to specialist technicians trained in use of the product.
In the event of a fault or erratic operation, turn off the power to the automation at the main switch.
Do not attempt to make changes or repair the main control panel; contact the person who installed the automation, or another special-
ist installer. Failure to observe this requirement can be dangerous.
The user is not permitted to either service the system and control equipment, or access the electrical box. In the event of a fault or pow-
er cut, it is possible to operate the GATE manually (refer to the actuator installation manual).
