Omron SYSMAC C200HW-PCS01-EV1, Руководство по эксплуатации

Страница: 63 / 261

47
5-2 Formatting Memory Cards
This section describes how to format memory cards.
5-2-1 Specifying the Card Format and Slot
The format differs according to the memory card being used.
•
SRAM and ATA Cards: DOS FAT format
•
FLASH Cards: MS-FLASH format
Use the system switch on the front panel of a PC Card Unit to specify the format
and the slot containing the card to be formatted.
Specifying the Card Format and Slot (Pins 4 and 3)
Note Restart the PC Card Unit to use new system switch settings. By default, all pins
are set to OFF. Change the switch settings as necessary.
Pin 4
Pin 3
Pin 4 and pin 3 settings Description
OFF
OFF
SRAM/ATA Card Format card in slot 1
OFF
ON
SRAM/ATA Card Format card in slot 2
ON
OFF
FLASH Card Format card in slot 1
ON
ON
FLASH Card Format card in slot 2
Note Memory cards can also be formatted using PCMCIA2.1-compliant equipment
such as personal computers. In this case, SRAM and ATA Cards must be for-
matted in FAT format, and FLASH Cards must be formatted in MS-FLASH for-
mat.
Newly purchased memory cards may not be formatted on the PC Card Unit. In
such a case, format them using a personal computer.
If a personal computer is not PCMCIA2.1-compliant, format the SRAM Card with
the following procedure using the PC Card Unit.
1, 2, 3... 1. Connect an ANSI terminal, such as the Hyperterminal for Windows 95, to
the PC Card Unit using a host link cable. Set the communications conditions
as follows:
9,600 bps, 8 bits, no parity, 1 stop bit
2. Set only pins 5 and 6 to ON, and then turn on the PC Card Unit.
3. Insert the SRAM Card into slot 2.
Formatting Memory Cards
Section 5-2