Omron SYSDRIVE 3G3JV-AB001, Руководство пользователя

Страница: 56 / 166

4-4
4-1 Procedure for Test Run
1. Installation and Mounting
Install the Inverter according to the installation conditions. Refer to page 2-2. Ensure
that the installation conditions are met.
2. Wiring and Connection
Connect to the power supply and peripheral devices. Refer to page 2-7. Select
peripheral devices which meet the specifications and wire correctly.
3. Power Connection
Carry out the following pre-connection checks before turning on the power supply.
H
Always ensure that a power supply to the correct voltage is used and that the power
input terminals (R/L1, S/L2, and T/L3) are wired correctly.
3G3JV-A2
S
: 3-phase 200 to 230 VAC
3G3JV-AB
S
: Single-phase 200 to 240 VAC (Wire R/L1 and S/L2)
H
Make sure that the motor output terminals (U/T1, V/T2, and W/T3) are connected to
the motor correctly.
H
Ensure that the control circuit terminals and the control device are wired correctly.
Make sure that all control terminals are turned off.
H
Set the motor to no-load status (i.e., not connected to the mechanical system).
H
Having conducted the above checks, connect the power supply.
4. Check the Display Status
Check to be sure that there are no faults in the Inverter.
H
If the display at the time the power is connected is normal, it will read as follows:
RUN indicator: Flashes
ALARM indicator: Off
Setting/Monitor indicators: FREF, FOUT, or IOUT is lit.
Data display: Displays the corresponding data of the indicator that is lit.
H
When a fault has occurred, the details of the fault will be displayed. In that case,
refer to
Chapter 7 Maintenance Operations and take necessary remedies.
5. Initializing Parameters
Initialize the parameters.
H
Set n01 to 8 for initialization in 2-wire sequence.
6. Setting Parameters
Set the parameters required for a test run.
H
Set the rated motor current in order to prevent the motor from burning due to over-
loading.
Test Run
Chapter 4