Omron SYSDRIVE 3G3JV-AB001, Руководство пользователя

Страница: 58 / 166

4-6
4-2 Operation Example
1 Power Connection
H
Checkpoints before Connecting the Power Supply
•
Check that the power supply is of the correct voltage and that the motor output termi-
nals (R/L1, S/L2, and T/L3) are connected to the motor correctly.
3G3JV-A2
S
: Three-phase 200 to 230 VAC
3G3JV-AB
S
: Single-phase 200 to 240 VAC (Wire R/L1 and S/L2)
•
Make sure that the motor output terminals (U/T1, V/T2, and W/T3) are connected to the
motor correctly.
•
Ensure that the control circuit terminals and the control device are wired correctly.
Make sure that all control terminals are turned off.
•
Set the motor to no-load status (i.e., not connected to the mechanical system).
H
Connecting the Power Supply
•
After conducting the above checks, connect the power supply.
2 Check the Display Status
•
If the display is normal when the power is connected, it will read as follows:
Normal
RUN indicator: Flashes
ALARM indicator: Off
Setting/Monitor indicators: FREF, FOUT, or IOUT is lit.
Data display: Displays the corresponding data for the indicator that is lit.
•
When a fault has occurred, the details of the fault will be displayed. In that case, refer to
Chapter 7
Maintenance
Operations and take necessary action.
Fault
RUN indicator: Flashes
ALARM indicator: Lit (fault detection) or flashes (alarm detection)
Setting/Monitor indicators: FREF, FOUT, or IOUT is lit.
Data display: The fault code, such as UV1, is displayed. The display will differ de-
pending on the type of fault.
Test Run
Chapter 4