Omron R7D-BP, Руководство пользователя

Страница: 269 / 328

7-4
7-2 Realtime Autotuning
7
Adjustment Functions
4. Machine Rigidity Selection
Œ
To increase responsiveness, gradually increase the setting of the Realtime Autotuning Machine
Rigidity Selection (Pn22).
Œ
If the machine produces an unusual noise or resonates, lower the setting.
5. Saving Gain Adjustment Values
Œ
To save the gain setting, change to Parameter Write Mode and save the parameters in EEPROM.
(For operation details, refer to
Parameter Write Mode on page 6-16.)
Operating Procedures
Œ
The setting of the Realtime Autotuning Mode Selection is changed when
the Unit power is turned ON, or when the RUN Command Input (RUN) is
turned ON.
Œ
To disable realtime autotuning, set Pn21 to 0, and then turn OFF the RUN
Command Input (RUN) and turn if ON again.
Precautions
for Correct Use
pknk_k k2k2.
pknk_k k2k1.
pknk_k k2k1.
pknk_k k0k0.
Uknk_kskpkdk
rk k k k k0k
4
1.
Setting Parameter Pn21
Press the Data key.
Press the Mode key.
Press the Increment or Decrement key to select
the parameter to be set.
(In this case, select Pn21.)
Press the Data key.
Press the Increment or Decrement key
to change the setting.
Press the Data key.
Setting Parameter Pn22
Press the Increment key to set the parameter
number to Pn22.
Press the Data key.
Press the Increment key to increase the setting.
Press the Decrement key to decrease the setting.
Press the Data key.
(Default setting)
Insert the connector of the Parameter Unit
into CN2 of the Servo Drive, and then
turn ON the power to the Servo Drive.