1- NS600 Installation
Quick reference NS600
OMRON EUROPE MAC centre
QUICK REFERENCE NS600.DOC
Pag. 2
1- NS600 Installation
Follow this step to install the NS600 board onto a W series servo.
1. - Take out the bus connector protector from the W series servo driver, this protector is at right side of the driver.
2. -Insert the lower clamps of the board into the holes on the bottom of the driver. (Right side)
3. - Pull the board following the arrow direction, an insert the top clamp onto the hole.
4. - To ground the board is necessary to use an Philips screw M3x10 up to 1 kW, M4x10 up to 5KW and M4x8 up to
15KW. Connect the cable with the G point on the servo driver and clamp it with the screw.
Earth
Up to 5KW
Up to 15KW
Содержание NS600
Страница 1: ...Mechatronics NS600 Quick reference...