4- programming software (INDEXWORK)
Quick reference NS600
OMRON EUROPE MAC centre
QUICK REFERENCE NS600.DOC
Pag. 21
4.3.- NS600 SETUP
4.3.1.- MECHANICAL SYSTEM.
On this window is possible to setup the mechanical system, the units to work (cm, inch,deg,..), selecting the associated
mechanical system the NS600 could calculate the ration between the user units and encoder pulses (pulse rate).
Parameters:
1.- Mechanical system selection (System): Leadscrewm, tangential/belt drive, material feeder, rotatory table or another
system.
2.- Setting up the mechanical system.
-
Machine Units Base
: mm, cm, inch, pie, degrees or rad; also the
Time base
in seconds or minutes.
-
Resolution:
fix the number of decimals (1 to 4) we will work in (1 x 10
-resolution
).
-
Mechanical:
lead
,
pitch diameter, feed roll diameter
,
modulus
or another. Attention: this value should be
set with 5 digits including decimals (resolution)
-
N1/N2
: indicates the reduction ratio.
With all these data the software calculates the PULSE RATE that should be introduced into servodriver’s parameters
Pn202 and Pn203.
3.-Another parameters:
-
Default speed
(Pn81E)
-
Acceleration
(Pn81Fn)
-
Deceleration
(Pn820)
-
In Position Window
(Pn821 INP o INP1)
-
Near Position Window
(Pn822 NEAR o INP2)
All this parameters has as a units the defined before.
Содержание NS600
Страница 1: ...Mechatronics NS600 Quick reference...