Omron HEM-9000AI, Инструкция по эксплуатации

Страница: 18 / 96

18
8.General Preparation
Turning on the power, and checking the time/date
7.
Insert the memory card into the slot on the right side
of the main unit.
All measurement data will be saved to the memory
card. The measurement results will not be saved if
the memory card is not properly inserted in or if
there is insufficient memory available on the card.
Note that since the file system takes up 7MB of
memory, the available space on a new card will be
slightly less than the total card memory. [Fig. 6]
8.
Load the printer paper.
(Refer to 8.5. “Loading Printer Paper”.)
9.
Plug the female end of the power cord into the back of the main unit. Then plug the male
end of the power cord into an electrical outlet with grounding.
10.
Press the “I” end of the power switch at the back of the main unit. [Fig. 7]
(After displaying “Starting up.... Please wait for a moment” for approximately 30 seconds,
the measurement screen will appear.) [Fig. 8]
11.
Check to be sure the time displayed on the upper
right corner of the screen is correct.
If necessary, see the following page for instructions
on how to set the time or date. [Fig. 9]
[Fig. 6]
[Fig. 8]
[Fig. 7]
[Fig. 9]