21
Merging Projects
Section 4-2
the
Transfer with the symbol table
Option in the
Send Options
of the CX-
Designer, and then resend the project.
4-2
Merging Projects
4-2-1
Merge Using the CX-Designer
Use the CX-Designer with the following procedure to merge an NS project
output using the Face Plate Auto-Builder for NS with an existing NS project.
Individually Copying
Screens
Selected screens can be copied. Screens can be copied from a project output
using Face Plate Auto-Builder for NS to an existing project by starting two
copies of the CX-Designer. Screens cannot be copied, however, if the system
version of the project copy destination is older than that of the project copy
source.
1,2,3...
1.
Select the screen to be copied from the Project Workspace and press the
Ctrl
+
C
Keys. Alternatively, right-click and select
Copy
from the pop-up
menu. Click the screens while pressing the
Shift
Key or
Ctrl
Key to select
multiple screens at the same time.
2.
Select the category in which to paste in the Project Workspace.
3.
Press the
Ctrl
+
V
Keys. Alternatively, right-click and select
Paste
from the
pop-up menu.
4.
Specify the number of the first screen after pasting, then click the
OK
But-
ton.
5.
If the
Reuse screen with sheet
option has been set, specify the number of
the first sheet after pasting, and then click the
OK
Button. (This operation
is necessary only if the
Reuse screen
with sheet option has been set.)
The screen will not be copied if the number of sheets after copying exceeds
ten.
Once copying has completed, a file in the format of
projectname.txt
will be
created in the folder where the project file (i.e., ipp file) is saved. The screen
numbers before copying and after copying can be checked.
Pasting Parts, Such As
Face Plates, into Separate
Projects
Copied or cut parts can be pasted to separate projects. Common settings that
the part references are also copied at the same time. (Refer to the note below
regarding common settings.) Parts cannot be copied, however, if the system
version of the project copy destination is older than that of the project copy
source.
Содержание Face Plate Auto-Builder for NS 3.1
