Omron Face Plate Auto-Builder for NS 3.1, Руководство по эксплуатации

Страница: 135 / 143

120
Segment Program 3 (Block Model 158) Section 6-19
6-19-2 Tuning Screens
1: Status Display
These button are used to switch between the status of the Stop block opera-
tion command (tag ITEM MT_ST (ITEM 000)) and Disable Reference Input
Switch (tag ITEM S5 (ITEM 020)). These buttons are built as alternate ON/
OFF Buttons using Simple Rectangles (Type 2), according to the information
in the following table.
The read address is set in the display address and the write address is set in
write address 1.
2: Alarm Setting/Parameters
Segment Program 3 does not provide alarm settings or parameter settings.
3: Realtime Trend Graph
Tag ITEM X1 (ITEM 007) and tag ITEM Y1 (ITEM 008) are displayed as
graphs. Each tag ITEM is drawn using the following graph lines.
1 2
3
4
5 6
Button Tag ITEM OFF color ON color OFF label ON label Write confirmation
message
Stop block operation
command MT_ST
(
ITEM 000
)
Gray Yellow Operating Suspended Yes
“OK?”
Disable reference
input S5
(ITEM 020)
Gray Yellow Ref. ON Ref. OFF Yes
“OK?”
AT command/AT
executing AT
(
026
)
Gray Yellow AT AT Yes
“Executing or stop-
ping the AT com-
mand will change the
MV. OK?”
Tag ITEM Color Minimum
value
Maximum
value
Line type Marker Step display
X1 Green
−
1500 11500 Solid line None Not used.
Y1 Yellow
−
1500 11500 Solid line None Not used.