Omnicomm LLS-AF sensor must be set to output a frequency signal in the range from
30 to 1053 Hz.
When connecting the video terminals to the “” system or the “PMP-201”
sensor:
“Fuel tank volume, L” – enter the fuel tank volume. Possible values: from 0 to 65,000
“Current fuel volume, L” – displays the current volume according to
the “” system or the “PMP-201” sensor
Connect the “PMP-201” sensor and the “” system according to the
documentation on these devices. You may connect only one “” system. The
network address, by default, is 80.
Omnicomm LLD Indicator
In the “Settings” tab select the “Auxiliary equipment” section from the list.
In the “Data transmission to Omnicomm LLD indicator” section:
“Data source” – select the data source to display the value on the Omnicomm LLD
indicator. Possible options:
“GPS speed” – displays the vehicle speed
“Universal input“ – displays the status or values on the terminal universal input
depending on the connected auxiliary equipment
“Engine hours by RPM” – displays vehicle engine hours
When selecting “Engine hours by RPM”, fill in the table of RPM recalculation to engine
hours as follows:
In the field “Revolutions per minute” enter the value of RPM, in the field “Factor” enter
the value of conversion factor to calculate the engine hours value.
The conversion factors are determined based on the operating conditions of the
vehicle. Maximum number of rows – 5.
Engine hours are displayed on the LLD indicator as hour values with a fractional part
Auxiliary Equipment
Omnicomm OKO video terminal
42