OMG MF 64, Инструкция по эксплуатации

Страница: 140 / 180

MF 64
Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com Pag. 139 a 179
NOTE: If the machine is in security exclusion mode, the manual movements are enabled only
pushed the reset button at the same time with the arrows for the direction shift.
The same way must be done for the lower table adjustment.
Pay attention to adjust the working position of the forming press with the mold installed properly.
Avoid crashing it against the index rails or against the lower mold. Increase the amount of width of
the rails for more safety. Not doing so may result in injuries or damage to the product.
Note: First move in open position the lower forming table. After, make the adjustments to the upper
forming table. It will avoid getting the tables into contact in case of a previous adjustment.
To finish, the final position of the mold must be in close position near the bottom of the film position
on the index rail.
Final position
Push here to change values.
Manual movements
Manual mov. speed:
Panda: max speed (100%)
Turtle: slow speed (20%)