![background image](http://html1.mh-extra.com/html/omega/cn616tc1/cn616tc1_user-manual_737599010.webp)
SECTION 3
INSTALLATION
3.1 Unpacking
Upon receipt of shipment, inspect the container and equipment for any
signs of damage. Take particular note of any evidence of rough handling
in transit. Immediately report any damage to the shipping agent.
Remove the packing list and verify that all equipment has been received.
Each package should contain:
• Controller (CN616)
• Operator's Manual
• RS-232 Software
• Two mounting slides with screws
• Power plug (9 pin)
• RS-232 plug (3 pin)
• Two T/C plugs (6 pin)
• Two Output plugs (6 pin)
If there are any questions about the shipment, please call the Customer
Service Department.
NOTE: The carrier will not honor any claims unless all shipping material
is saved for their examination. After examining and removing contents,
save packing material and carton in the event reshipment is necessary.
3.2 Mounting
Select a location for the controller that is free from excessive shock,
vibration, dirt, moisture and oil. Mount the controller into a 3 5/8"
(92mm) square cutout. The controller as shipped is 1/4 DIN (92mm
square), so it does not have to be removed from it's housing to be
mounted.
Remove the two screws that secure the mounting slides. Remove the
slides and insert the case into the cutout from the front side of the panel.
Reinstall the two slides and two screws. The length of the slides must be
reduced if the controller is to be mounted in an extra thick panel.
15
3.4 Wiring the Power Circuit
The line voltage for the controller is selected by an external jumper
assembly to operate either on 120VAC or 240VAC±10%, 50/60Hz
(factory wired for 120VAC). It is very important that the proper line
voltage is connected to the instrument. If 120VAC is connected to a
240VAC model, it will not work properly. A 120VAC instrument
connected to 240VAC will overheat and burn the input transformer.
3.3 Outline Dimensions
3.62"
(92mm)
6.0" (152mm)
3.62"
(92mm)
!
WARNING! !
The controller is powered with either 120
or 240 VAC. To avoid electric shock or
fatality hazards the power to the controller
lines must be switched off at the main
switch, or circuit breaker before the
controller A/C wiring, including the line
selector jumpers can be handled.
16
Содержание CN616TC1
Страница 9: ...13 14 ...