Olympic Medical BILI-LITE 33, Инструкция по эксплуатации, Страница: 41 / 56

OLYMPIC BILI-LITE Model 33/34 Instruction Manual 6-11
Repair Procedures
Replacing the Starter
If the fan runs and the bulbs have been replaced but a bulb doesn’t light, replace
the starter.
Required Items:
„
Starter
„
Nutdriver
„
Screwdriver
To replace the starter:
1
Press the power switch to the
OFF
(O) position, then unplug the power cord.
2
Remove the safety shield: First, remove the two retaining screws and washers.
Next, slide the safety shield out.
3
Rotate each bulb out of its socket; set the bulbs aside in a secure place.
4
Locate the starter for the bulb that does not light. Replace the damaged starter
(see Figure 6.7):
a
Push in and turn the starter to remove it from its locked position in
the socket.
b
Push in and turn the new starter to secure it into the locked position.
Figure 6.7 Bulb starter
5
Install the bulbs (for placement, see page 5-2).
6
Slide the safety shield back into the light hood, then secure it in place with the
retaining screws and washers.
7
Perform the test procedure (see page 2-8).
Bulb holder
Starter socket
Starter