Olsen PERFORMANCE TABLE, Руководство пользователя

Страница: 17 / 72

17
5.15.1 - Premium LED (Optional)
The Premium LED operating light features
indirect illumination from 8.000 to 30.000 lux
generated by LED directed to the multifaceted
mirror with gradual and cyclic intensity control.
To turn On/Off the operating light: pass the hand in front of the
sensor (5) approximately 5 cm away or press the control knob (4).
To change the light intensity: hold your hand in front of the
sensor (5) or turn the control knob (4) until the operating light shows
the desired intensity.
Only in case Performance Table has 3 motors, it will be
necessary before turning on the operating light, as follows: press the
On/Off operating light command (1) on the remote foot pedal to enable sensor (5) and control knob (4).
The handles (2) can be removed by removing the securing screws (3).
5.15.2 - Surgical Operating Light (Optional)
The surgical operating light is 30.000 lux intensity generated
by 6 LED spotlights distributed to provide a wide area of illumination
for outpatient procedures.
To turn on/off the surgical operating light: use the switch (8).
To move the surgical operating light, use the metal handle (6)
or the side handles (7). The metal handle (6) can be removed for
autoclaving by turning it counterclockwise.
It is recommended that the side handles (7) be packed with
disposable material (per exemple plastic film) to prevent cross-
contamination and damage to the equipment's fairings.
6 - General Features
−
Upholsteries: are assembled on a very resistant frame, with soft foam and coated with flexible laminated
PVC or leather, which besides being resistant, providing easy asepsis for the whole.
−
Mechanical structure: manufactured in SAE 1020 rolled steel profiles and welded by MIG process, to
guarantee the strength and durability.
−
Electrostatic painting: it is applied to all structural metal parts of the equipment. The special polyurethane
paint provides the equipment with high durability coating and has antibacterial properties according to
JIS Z 2801: 2000 , where in 24 hours, the bacterial reduction is greater than 99.9%.
−
Plastic covers: made of high-strength ABS with acrylic cover, the plastic covers do not require painting and
allowing polishing for recovery in case of wear or scratches.
−
Electrical system: the equipment can work in frequencies of 50 or 60 Hz and can be configured to be
connected to the voltages of 118/127/220/230 Volts by an authorized technician. The maximum
supply voltage of electronic boards, motors, and other controls is 24 V. The electrical system has On/Off
switch and protection fuses.
−
Spindle drive motor: all motors used in the equipment are produced by Robert Bosch of Brazil and have
advantages such as low noise, the absence of oil reservoir, uniformity in displacement, reduction of
energy consumption and low cost for maintenance. The motors also have protection systems that act
on the mechanical and electrical parts of the set.
−
Pressurized suspension: the high pressure nitrogen cylinder relieves the load of the gear motor lifting
system of the equipment in 100 kg. This means that a patient with this approximate weight is not acting
on the electromechanical lifting components.