Oliver MODEL 619-MDP, Инструкция по эксплуатации

Страница: 13 / 38

0619S20148 4-3
Lubrication
The machine requires no lubrication but the oil level in the hydraulic system should be
checked periodically. To check the oil level remove the rear cover by removing the four
knobs which secure it to the divider, then remove the tank breather/cap and determine
where the top of the oil is in relation to the top surface of the tank. Fill with oil to within
approximately one inch of the top surface. If necessary add
HYDRAULIC OIL
to return
it to the proper level,
DO NOT OVERFILL
. In addition to the above we advise replacing
the hydraulic oil in the system approximately every three years.
Hydraulic Oil Specification
The hydraulic oil used in your divider should be made of good quality base stocks
compounded with the following additives: anti-wear, anti-oxidation, antifoaming, and
antirust. In addition it should be an
“ISO” viscosity grade No. 32.
Hydraulic Filter Replacement
At least once a year the throw-away filter on the hydraulic system should be replaced,
more often when under heavy use. To replace the filter disconnect the machine from the
power supply, remove the front cover and unscrew the old filter. Replace it with a new
one. The filter is located on the return line near the tank. After replacing the filter run
the machine for five minutes and then check the oil level in the tank. See
“Lubrication”
above for how to check the oil level. Add oil if necessary to return it to the proper level.
Removing The Lid
·
Remove the lid cover by removing the four screws which secure it in position.
·
Open the lid as far as it will go.
·
Release the tension on the two large torsion springs by moving the long leg of each
spring to the side and out from behind the bracket.
WARNING
USE CARE AS THE LID WILL DROP ONCE THE
SPRING TENSION HAS BEEN REMOVED
·
Close the lid and remove the right hand snap ring from the lid hinge pin and push the
pin to the left to remove it.
·
Reassemble by reversing the above steps.