Oliver MODEL 619-MDP, Инструкция по эксплуатации

Страница: 9 / 38

0619S20131 3-1
619-MDP DOUGH PRESS
OPERATING INSTRUCTIONS
Before You Start
CAUTION
THE DOUGH PRESS SHOULD
ONLY
BE PLUGGED INTO AN OUTLET
WITH THE SAME VOLTAGE AS STATED ON THE NAMEPLATE
Before starting a new dough press with
THREE PHASE
electrical power for the first time
you should check to see if the motor is running in the correct direction. Remove the front
cover by removing the four thumbscrews which secure it; you will also have to remove
the handle from the directional control lever before removing the front cover. Once the
cover has been removed you should be able to see the fan end of the motor on your
dough press, this fan
MUST
rotate in a clockwise direction.
CAUTION
EXTENDED RUNNING OF A DOUGH PRESS WITH THE MOTOR
ROTATING IN THE INCORRECT DIRECTION WILL SEVERELY
DAMAGE THE HYDRAULIC PUMP OF YOUR MACHINE.
If the motor is rotating in the incorrect direction turn the machine off, disconnect it from
the power supply and have a qualified electrician reverse two of the three power wires in
the plug at the end of the power cord.
DO NOT
move the ground, (green), wire.
WARNING
ALWAYS HAVE ELECTRICAL WORK DONE BY QUALIFIED
ELECTRICIANS ONLY.
Recheck the dough press making sure that it is now running in the correct direction,
(clockwise looking at the fan end of the motor). Each time the machine is moved to a
different power supply or has electrical work done which could alter the motor rotation,
the motor must be rechecked for proper rotation.
Basic Operation
·
Make sure the floor of the hopper has been lowered before attempting to open the lid
of the divider.
·
Open the lid and load the dough into the hopper. Spread the dough over the floor of
the hopper making it approximately the same height, this is done to eliminate large
air pockets.