Oliver MODEL 619-MDP, Инструкция по эксплуатации

Страница: 14 / 38

0619S20148 4-4
Replacing The Locking Hook Or Cam:
·
Remove the lid cover by removing the four screws which secure it in position.
·
Detach the spring from the hook.
·
Open the lid.
·
Turn the handle until the pin securing the cam to the shaft is in line with the notch in
the locking hook. Using a small drift punch force the pin upwards removing it from
the handle shaft.
·
Pull the shaft and cam assembly forward out of the lid.
·
The hook or locking cam can now be replaced.
·
Reassemble by reversing the above steps.
Replacing A Pressing Plate
·
Open the lid and raise the bottom of the hopper.
·
Turn the machine off and disconnect it from the power supply.
·
Remove the front and rear panels to gain access to the pusher components.
·
Remove the sixteen screws securing the pressing plate to the backing plate.
·
Using a narrow block of wood or other soft material, force the pressing plate upwards
until it is free from the backing plate and then lift the pressing plate out of the cavity.
·
Reassemble by reversing the above steps.
Removing the Backing Plate
·
Remove the Pressing Plate as described above.
·
Remove the bolt securing the backing plate to the cylinder rod. The backing plate
can now be lifted from the machine.
·
When the machine is re-assembled the bolt securing the backing plate to the cylinder
rod should be installed using
“Loctite ®” adhesive to prevent loosening during
operation. The remaining components can be reinstalled by reversing the above
steps.