Oliver 4430.201 M-4430, Руководство пользователя

Страница: 34 / 65

34 | Page Oliver Machinery 4430 Planer
If the machine stalls or the workpiece gets stuck:
•
Headstock height is set too low.
•
Stop the machine and wait for the machine to come to a complete stop.
•
Raise the headstock and remove the workpiece.
•
Reduce the depth of cut, and restart from step 3.
5. If the workpiece is feeding properly, wait until the entire workpiece clears the outfeed roller, then
remove the workpiece.
6. After the initial pass, measure the thickness at the midsection of the workpiece.
If more material needs to be removed, continue with the following steps.
7. If you need to remove a lot of material, run a few passes with deeper cuts, then finish with a light pass
with shallow cuts and a low feed rate.
8. Turn on the digital readout (DRO), and use the INC mode to measure the depth of cut for each pass.
If your DRO is already running in INC mode, you can reset the readings by switching to ABS mode and
then come back to INC mode.
9. Using the DRO as a depth gauge, lower the cutterhead. Each pass should remove no more than 1/8”
for workpiece wider than 8”, and no more than 1/4" for workpieces 8” wide or less. Reduce the
maximum depth of cut for harder wood types.
10. Upon completion of each pass, reset the reading of DRO. Use a caliper to measure the workpiece’s
mid-section thickness, and decide the depth of cut for the next pass.
11. Repeat the process until the desired thickness is achieved.
Turn the machine off when the operation completes.