Oliver 4430.201 M-4430, Руководство пользователя

Страница: 37 / 65

4430 Planer OLIVERMACHINERY.NET 37 | Page
Maintenance
Routine maintenance keeps your planer in top shape. Please follow the maintenance schedule below,
and use the maintenance record worksheet attached in the back of the manual to document all tasks
completed.
NOTICE: Maintenance schedule may vary for individual users due to different situations and
safety requirements.
WARNING
Disconnect the machine from the power source before any maintenance work is
performed. After servicing the planer, remove all wrenches and tools before
restarting the machine. Failure to comply can cause serious injury!
Maintenance Schedule
Interval Component
Every day Remove dust buildups from the planer and dust collection system.
Inspect the power cord for signs of aging and damages. Replace as needed.
Every week Inspect and clean cutterhead, rollers, and anti-kickback fingers. Remove any
dust and resin accumulation.
Inspect/rotate/replace worn cutter inserts.
Apply rust protectant on unpainted cast iron surfaces.
Verify extension tables are level with the planer bed. Adjust as needed.
Every month Check V-belt tension and replace if the belt shows signs of cracking or glazing.
Every 4-6 months Remove dust buildups from the motor and the cabinet.
Inspect headstock chain for chain slacks.
Check parallelism between the table and cutterhead, and the rollers.
Notice : Motor bearings are permanently sealed and lubricated, and do not require lubrication.
Lubrication Schedule
Component Interval Types of Lubricant Reference
A - Return roller shafts Every week SAE 30 oil. Figure 1
B - Feed roller shafts Every 30 hours SAE-30 oil.
C - Drive chains and
sprockets Monthly General purpose grease
Figure 2
D - Lead screws (x4) Once every 3 months General purpose grease
E - Columns (x4) Clean and lubricate
weekly A light coat of SAE-30 oil
F - Gearbox Replace gearbox oil
after the first 50 hours of
use, then replace the oil
every year. Standard gear oil, 70-90 weight.
Remove gearbox cover to access drain plug
and fill plug. Drain and recycle used oil. Refill oil
until it reaches the fill plug.
Figure 3
G - Outfeed roller Clean and
lubricate as
needed. A very light coat of SAE-30 oil. Figure 4
H - Infeed roller
I - Anti-kickback fingers
J - Bed roller Figure 5
K - Headstock chain
and sprockets Every 4 to 6
months Grease, or good quality cycle chain lubricant.
Remove the motor access panel to access
components.
Figure 6