Oliver 4430.201 M-4430, Руководство пользователя

Страница: 15 / 65

4430 Planer OLIVERMACHINERY.NET 15 | Page
When Planning:
1. DUST COLLECTION SYSTEM is required for this planer. Please make sure the system is on and provide
enough suction before work begins.
2. KICKBACK happens when a workpiece is ejected, usually towards the infeed side of the planer, during
the operation. This can cause serious injuries or even death. This planner is equipped with metal anti-
kickback fingers to reduce the risk of kickback. Make sure they are clean and moving freely before
work begins. Even with this safety device installed, kickback can still happen due to workpiece quality,
grain orientation, and many factors. The operator should be cautious about possible kickbacks.
•
ALWAYS wear proper protection devices and stay away from the line of fire to avoid kickback-
related accidents.
•
NEVER look inside the planer during operation.
•
NEVER plane boards that are shorter than 7” as mentioned in the specifications.
3. PROPER WORKPIECE FEEDING avoids kickback. Never start the machine with the workpiece engaging
the cutterhead. Never start feeding until the planer has reached its full speed. Ensure the feeding
rollers grip firmly on the workpiece.
•
NEVER force a workpiece through the planer. Make adjustments as needed.
•
ONLY plane one board at a time.
•
For twisted workpieces, use a jointer to face joint the bottom side of the workpiece before
planning.
4. STUCK WORKPIECE should be removed only after the planer is powered off, and the cutterhead
comes to a complete stop. Do not use hands or push sticks to force-feed a workpiece through the
planer, as it can result in severe injuries and/or machine damage.
5. DEPTH OF CUT SETTINGS: Never exceed the designed maximum depth of cut capacity found in the
specification. Failing to comply can cause machine damage and injuries. Consider the hardness of the
workpiece when setting the depth of cut, as harder wood types increase the workload of the planer.
After Operation
1. STOP THE MACHINE if the operator leaves the machine for any reason.
2. WAIT until the machine comes to a complete stop.
3. CLEAN UP the work area before departure.