Oleo-Mac OM 106, Инструкция для оператора

Страница: 64 / 344

64
MOWING DECK PROBLEMS
PROBLEM POSSIBLE CAUSES REMEDY
THE MOWING DECK
MOWS UNEVENLY
Grass and dirt accumulated inside the
mowing deck ► Remove the dirt from the underside of the mowing
deck.
Blunt or deformed blades
► Check the condition of the blades and sharpen or
replace as necessary (
6.3.6 )
Damaged or worn out blade shaft ► Check the condition of the shaft.
One or both the belts are insufficiently
tensioned ► Check the tension and tension it if necessary
(
6.3.8 and 6.3.9 ).
AN UNMOWED STRIP
REMAINS BETWEEN
THE BLADE ROTORS
Blunt or deformed blades
► Check the condition of the blades and sharpen or
replace as necessary (
6.3.6 )
Damaged bearing housing
► Check the condition of the bearings and based on
findings perform a repair or replacement. When
mowing thick grass or grass that is too wet, an
unmowed strip may remain. The travel speed should
be adjusted to respect the mowing conditions by
shifting into a suitable gear. The engine should not run
with the throttle valve fully open.
THE MOWING DECK IS
RIPPING OUT TURF
Bent blades
► Check the condition of the blades and replace as necessary
(
6.3.6 )
Damaged bearing housing
► Check the condition of the bearings and based on
findings perform a repair or replacement.
The drive belt is insufficiently tensioned
► Check the tension of the drive belt ( 6.3.8 a 6.3.9 )
a v p ř ípad ě pot ř eby jej napn ě te.
Inappropriate mowing height
► Check the mowing height and adjust if necessary. Turf
is ripped out more frequently on uneven terrain.
THE MOWING DECK
DOES NOT EJECT
GRASS
Grass has accumulated inside the
mowing deck
► Remove the grass from the underside of the mowing
deck. In wet conditions, the ejection chute and the
lower side of the outlet from the mowing deck may clog
up with grass. Do not mow wet grass.
The drive belt is insufficiently tensioned
► Check the tension of the drive belt ( 6.3.8 a 6.3.9 )
a v p ř ípad ě pot ř eby jej napn ě te.
Inappropriate travel speed
► The travel speed should be adjusted to respect the
mowing conditions by shifting into a suitable gear. The
engine should not run with the throttle valve fully open.
When mowing high grass, first mow once at a high
mowing height, then once more at the normal height.
Follow the information in chapter
5.5.3 .
Incorrectly installed blade
► Check, particularly after replacing blades, that the
blade is installed correctly.