Olec OLITE, Руководство по обслуживанию

Страница: 55 / 118

94MS20 Rev. B4 5-29
Signal Description (64MV210A)
Lamp Signal : V~ going to lamp.
Low Expose: Input of 110V~ from timer/integrator activates a low
powered exposure.
Power Connector
P1)
AC Hot: Supply to board. It is equal to the line voltage on 110V~
equipment, an approximately 130V~ on the 208/240V~ equipment.
P2)
A C C o mmon: C o mmon to board, also is common for relays, shutter fans,
and the internal lamp head interlock. (This may not be at ground potential
and should be measured with caution).
P3) Lamp Fans: V~ proportional drive output for the blowers in the lamp head.
P4) Shutter: V~ output to drive the shutter motor.
P5)
High: V ~ O utput to drive the high relay which engages the high power
capacitor bank during warm-up and high power exposures.
P6) Power: Switch 110V~ output to power on off switch.
P7)
High/Low: Switch 110V~ output to high/low intensity switch. Switch must be
at high power to be controlled externally from an integrator.
P8)
Power Relay: V~ Output to drive the main relay. This provides power to the
lamp circuit.
P9) O p tical C o upler: N o t used.
P10)
Aux: Terminal connects to the signal connector for accessories (N o t used in
most equipment).
P11)
D C C o mmon: C ircuit common for low voltage signals from the lamp (This
may not be the same potential as V~ C o mmon connection and should never
be interchanged).
P12)
Input: 110V~ from timer/integrator activates a low or high powered
exposure (Intensity switch on power supply must be set on high power to get
a high powered exposure).
P13)
Input: 110V~ from timer/integrator activates a low or high powered
exposure (Intensity switch on power supply must be set on high power to get
a high powered exposure).
P14) Manual Expose: Switch 110V~ output to manual expose switch.