Installing Your Machine
- 19 -
Setup
1
15
Reinstall the image drum in the
printer:lower it into place in the printer
locating the pegs (1) at each end into
their slots in the sides of the printer
cavity (2).
16
Turn the lever in the direction shown.
The arrow on the lever should align with the arrow on
the image drum.
When the toner cartridge is not fully fixed , a decline in
print quality may occur.
17
Close the top cover.
18
Close the scanner unit.
Reference
Please refer to
for information on
how to load paper into the machine.
Turning On and Off Your Machine
Power Supply Conditions
The power supply must meet the following
conditions:
Note
If the power supply is unstable, use a voltage regulator.
The maximum power consumption of this machine is
950W. Ensure that the power supply is sufficient to operate
this machine.
We do not guarantee the operation where an uninterruptible
power system (UPS) or inverter is used. Do not use an
uninterruptible power system (UPS) or inverter.
Current:
110 - 127VAC
(Range 99 - 140 VAC)
220 - 240VAC
(Range 198 - 264VAC)
Frequency:
50/60 Hz ± 2%
1
1
2
2
There is a risk of getting
an electric shock and/or
causing fire.
Be sure to cut off the power supply when attaching
or removing the power supply plug or the earth
wire.
Be sure to connect an earth wire to the grounding
terminal of exclusive use.
Please do not connect with the ground of a water
pipe, a gas pipe, and a telephone wire, or lightning
rod without fail.
Make sure to connect with the ground terminal
before connecting the power cord to the power
supply plug.
Be sure to perform extraction and insertion of the
power cord with a power supply plug.
Insert the power supply plug into the wall socket
securely.
Do not touch the power cord, or machine, if your
hands are wet.
Install the power cord in a location where it will not
be stepped on, and do not place objects on the
power cord.
Do not twist, bind, or knot the power cord.
Please do not use a damaged power cord.
Do not carry out foot wiring.
Do not connect this machine and other electric
products to the same wall socket. If connected
simultaneously with an air-conditioner, a copy
machine, shredder, etc., electric noise may
interfere with operation. When the connection with
the same wall socket is unavoidable, please use a
commercial noise filter or a commercial noise cut
transformer.
Use the attached power cord and insert it directory
with the ground terminal. Do not use power cords
intended for other products with this machine.
Do not use an extension cord. When use is
unavoidable, use a cord rated higher than 15A.
Use of an extended cord may cause AC voltage
decrease and interfere with normal operation.
During printing, do not shut off the power supply
or pull out the power supply plug.
When not in use for consecutive holidays or long-
term travel, pull out the power cord.
Do not use the attached power cord for other
products.
WARNING
