22. Removing the Duct Gear
Assy. and the Duct Drive
Assy.
22.1. Release the tab at
the rear and
remove the Middle
Cover.
22.2. Lift the connector
for the waste toner
motor to wiring
harness from
under the motor’s
printed wiring
board.
NOTE
: Orange connectors
are soldered to the board and
are not removable. DO NOT
try to remove the orange
connector from the printed
wiring board.
28
Содержание C910
Страница 4: ...This Page Is Intentionally Blank IV...
Страница 16: ...13 4 Remove the Op Panel Cover 13 5 Remove 1 screw 13 6 Gently unplug the ribbon cable 12...
Страница 22: ...16 8 Slide the Controller Board slightly to the right and remove 17 Removing the Engine Board 18...
Страница 40: ...26 Removing the Paper Feed Unit 26 1 Remove four screws and remove the Metal Right Side Cover 36...