![background image](http://html1.mh-extra.com/html/oki/c910/c910_service-training_4104261028.webp)
NOTE
: On reassembly
insure that the
paper exit
sensor on the bottom of the
exit guide
is completely
snapped into it correct
position.
The correct threading for the
exit tray guide cable harness
is through the wire guide in
the rear of the printer cavity.
When reassembling also
insure the cable threading
around the Exit Guide
Assembly gearing. It is very
easy to pinch wires or get
them too close to the gearing.
24
Содержание C910
Страница 4: ...This Page Is Intentionally Blank IV...
Страница 16: ...13 4 Remove the Op Panel Cover 13 5 Remove 1 screw 13 6 Gently unplug the ribbon cable 12...
Страница 22: ...16 8 Slide the Controller Board slightly to the right and remove 17 Removing the Engine Board 18...
Страница 40: ...26 Removing the Paper Feed Unit 26 1 Remove four screws and remove the Metal Right Side Cover 36...