14. Removing the Plate
Shield Assy. (Rear
Metal Cover)
14.1. Be sure the
Top Cover is
closed. Loosen
the 2 captured
thumb screws
on the side and
remove the 2
screws along
the top.
NOTE
: Be careful when
handling any sheet metal
as there may be sharp
edges left over from the
manufacturing process.
14.2. Lifting up and
at the angle
shown, remove
the Plate
Shield Assy.
13
Содержание C910
Страница 4: ...This Page Is Intentionally Blank IV...
Страница 16: ...13 4 Remove the Op Panel Cover 13 5 Remove 1 screw 13 6 Gently unplug the ribbon cable 12...
Страница 22: ...16 8 Slide the Controller Board slightly to the right and remove 17 Removing the Engine Board 18...
Страница 40: ...26 Removing the Paper Feed Unit 26 1 Remove four screws and remove the Metal Right Side Cover 36...