Oilon RE 110, Инструкция по установке и эксплуатации

Страница: 33 / 52

RE03 1406 EN 31 (48)
Wireless remote control (optional extra)
Operating line number Function
120 Connection
121 Test mode
Heating circuit 1 / Heating circuit 2
Operating line number
(Heating circuit 1 / heating circuit
2)
Function
710 / 1010 Comfort setpoint
Set room temperature that heating circuit must
reach in comfort mode.
712 / 1012 Reduced setpoint
Set room temperature that heating circuit must
reach in reduced mode.
720 / 1020 Heating curve slope
See chapter Configuring heating curve .
721 / 1021 Heating curve displacement
If curve slope is suitable for heating circuit, but
room temperature is constantly too low or high
in comparison to set value, temperature can be
changed from operating lines.
‘+’ adjustment increases circulation setting and
room temperature
‘-’ adjustment decreases circulation setting and
room temperature.
730 / 1030 Summer/winter heating limit
Temperature when heating circulation is switched
on/off. Only operational in automatic mode.
740, 741 / 1040, 1041 Flow temp setpoint min, Flow temp setpoint max
Set maximum and minimum temperature for
heating circuit supply water temperature range.
This is a useful way for example to limit supply
water temperature sufficiently low at floor
heating locations. Floor heating circuit maximum
temperature should be limited to 40 °C. So called
floor drying function can be carried out by limiting
maximum temperature to 18 °C.
Domestic hot water
Operating line number Function
1610 Nominal setpoint
Domestic hot water temperature setting at nominal
mode (sun).