Oilon RE 110, Инструкция по установке и эксплуатации

Страница: 25 / 52

RE03 1406 EN 23 (48)
a. Press the
OK
button to access the menu system.
b. Press the Information (i) button for 5 seconds, select Commissioning user
level and press
OK
button.
3. Take the heating circuit into use.
a. Select Configuration menu and press OK button.
b. Select free heating circuit (
5710 Heating circuit 1
or
5715 Heating circuit 2
) to
be added and press the
OK
button.
c. Change the value to On and press the OK button.
d. Select operating line
6200 Save sensors
, give value
Yes
and press
OK
button.
4. Configure the heating curve and flow temperatures for the heating circuit, see
chapter Configuring heating curve .
3.6. Configuring heating curve
1. Press the OK button to access the menu system.
2. Select the correct heating circuit settings menu and press the
OK
button.
Depending on the heating circuit that you want to configure, select Heating
circuit 1
or
Heating circuit 2
.
3. Select
Comfort setpoint
and press the
OK
button.
4. Set the correct comfort setpoint value and press the OK button. This value is used
as the basis for the heat curve calculation.
5. Select
Heating curve slope
and press the
OK
button.
6. Set the correct heating curve slope and press the OK button.
Depending on the heating system type of the building, the recommended values
are:
● Approximately 0.4 for houses with floor heating
● Approximately 0.6 for houses with radiator heating
It is not recommended to use bigger value than 1.0.
The following figure displays different heating curves all of which are based
on an indoor temperature of 20 °C. The horizontal axis shows the ambient
temperature outdoors and the vertical axis shows the water temperature as it
enters the heating circuit.
0
0.2
0.4
0.6
0.8
1
20 15 10 5 0 -5
-10 -15 -20 -25 -30 -35 -40
10
20
30
40
50
60
70
°C
°C
HC ver. 2
7. Select Flow temp setpoint min and press the OK button.
8. Set the correct value and press the
OK
button.
9. Select
Flow temp setpoint max
and press the
OK
button.
10. Set the correct value and press the OK button.