4/Service
4-9
4-9
6600 0341 000
08/15/99
Replacing the bulb holder
WARNING
w
w
w
w
w
Allow the bulb to cool for at least ten minutes before attempting to remove it.
1. Disconnect the power cord.
2. Place the light source in its vertical position. Remove the four cover screws and
washers.
3. Gently slide the cover off, pulling it back away from the bezel, being careful not to
scratch the finished surfaces.
4. Open the bulb access door.
5. Remove the bulb.
6. Remove the mounting screws that hold the bulb holder to the main chassis.
7. Install the replacement bulb holder.
8. Reassemble the light source by reversing steps one through five.
9. Perform the electrical safety procedures detailed near the end of this section.
10. Perform the checkout procedure detailed in section 2/Operation before placing the
BiliBlanket Plus High Output in service.
Replacing the power inlet module
1.
Disconnect the power cord.
2.
Place the light source in its vertical position. Remove the four cover screws and
washers.
3.
Gently slide the cover off, pulling it back away from the bezel, being careful not to
scratch the finished surfaces.
4.
Place the light source in its horizontal position.
5.
Release the power inlet module from the chassis by the two screws on the side of
the module. Slide the module out of the chassis with the wire terminals still at-
tached.
6.
If necessary, snip any cable ties holding the module terminals. Remove the wire
terminals one at a time from the module, attaching each one to the same location
on the replacement module. Be sure to match the wire placement exactly. Install a
new cable tie (if one was removed) to hold the terminals to the replacement mod-
ule.
7.
Insert the module replacement into the chassis. Make sure the labels face toward
the outside of the light source.
8.
Reassemble the light source by reversing steps two through five.
9.
Perform the electrical safety procedures detailed near the end of this section.
10. Perform the checkout procedure detailed in section 2/Operation before placing the
BiliBlanket Plus High Output in service.
Содержание BiliBlanket Plus
