4/Service
4-6
4-6
6600 0341 000
08/15/99
W A R N I N G
w
w
w
w
w
For protection against fire hazard, replace a fuse only with the correct
type and rating of fuse, as listed in Specifications in the Appendix.
5.
Insert a new fuse in the holder, slide the holder back in, and close the fuse door.
6.
Perform the checkout procedure detailed in section 2/Operation.
Replacing the light source cover
1.
Disconnect the power cord.
2.
Place the light source in its normal vertical position and remove the four cover
screws and washers.
3.
Gently slide the cover off, pulling it back away from the bezel, being careful not to
scratch the finished surfaces.
Note: The rear panel and label are a part of, and come off with, the light source cover.
The power inlet module, however, remains fastened to the chassis when the light
source cover is slipped off.
4.
Gently slide the replacement cover onto the light source, being careful not to
scratch the finished surfaces.
5.
Replace the cover screws and washers.
6.
Perform the electrical safety procedures detailed near the end of this section.
7.
Perform the checkout procedure detailed in section 2/Operation before placing
the BiliBlanket Plus High Output in service.
Replacing the PC board
1.
Disconnect the power cord.
2.
Place the light source in its vertical position. Remove the four cover screws and
washers.
3.
Gently slide the cover off, pulling it back away from the bezel, being careful not to
scratch the finished surfaces.
4.
Place the light source in its horizontal position. The circuit board is near the fan.
5.
Remove the four nuts and washers which hold the circuit board to the main
chassis. Lift the board out.
6.
Remove the connectors from the board and insert them fully into the sockets
on the replacement board.
7.
Install the replacement board by reversing steps two through five.
8.
Perform the electrical safety procedures detailed near the end of this section.
9.
Perform the checkout procedure detailed in section 2/Operation before placing the
BiliBlanket Plus High Output in service.
Replacing the cooling fan
1.
Disconnect the power cord.
2.
Place the light source in its vertical position. Remove the four cover screws and
washers.
3.
Gently slide the cover off, pulling it back away from the bezel, being careful not to
scratch the finished surfaces.
4.
Place the light source in its horizontal position. Remove the four screws and
washers which hold the cooling fan to the main chassis. Note the orientation of the
fan.
Содержание BiliBlanket Plus
