Ohmeda BiliBlanket Plus, Руководство по эксплуатации, техническому обслуживанию и ремонту

Страница: 32 / 48

4/Service
4-10 4-10
6600 0341 000 08/15/99
Replacing a bezel/hour meter
1. Disconnect the power cord.
2. Place the light source in its vertical position. Remove the four cover screws and
washers.
3. Gently slide the cover off, pulling it back away from the bezel, being careful not to
scratch the finished surfaces.
4. Place the light source in its horizontal position.
5. Remove the four screws that secure the fan and remove the fan.
6. Remove the two screws on the bezel and the screw on the mode select slide lever,
and remove the bezel.
7. Loosen the two set screws on the brightness control knob and remove the knob.
8. Remove the connector (P7) from the printed circuit board.
9. Remove the heat shrink that surrounds the potentiometer.
10. Remove the nut on the potentiometer and remove the potentiometer.
11. Remove connector (P8) from the PCB.
12. Remove the hour meter by removing its two mounting screws.
13. To reassemble, reverse steps 1 through 12.
14. Perform the electrical safety procedures detailed near the end of this section.
15. Perform the checkout procedure detailed in section 2/Operation before placing the
BiliBlanket Plus High Output in service.
Replacing a front bezel label
A front bezel label may be replaced without disassembling the light source. To replace
a front bezel label, use the following procedure.
1. Disconnect the power cord.
2. Place the light source on its rear panel so the front bezel is facing up and can be
easily accessed.
3. Note the exact placement of the label on the bezel. With a pointed instrument,
gently pry and lift up a corner of the label enough to grasp it with your fingers.
4. Gently peel it back until it is off the bezel.
5. Remove the protective backing from the replacement label.
6. Carefully center the cutout(s) of the replacement label over the component
opening(s) on the bezel, aligning the label corners properly. Press the whole label
into place.