OEM OPM223, Руководство по эксплуатации

Страница: 79 / 104

OPM223/253 Trouble-shooting
79
E041
Calculation of calibration
parameters aborted
Repeat calibration and renew buffer solution;
replace electrode if necessary, check device
and measuring cable with simulator.
Yes No — —
1
E042
Distance of calibration value for
buffer pH 2 from zero (pH 7) too
short
Use buffer solution that is at least
Δ
pH = 2
from electrode zero point.
Yes No — —
1
E043
Distance between calibration
values for pH 1 and pH 2 too
short
Use buffer solutions that are at least
Δ
pH = 2
apart.
Yes No — —
1
E044
Stability requirement for
calibration not fulfilled
Repeat calibration and renew buffer solution;
replace electrode if necessary, check device
and measuring cable with simulator.
Yes No — —
1
E045 Calibration aborted
Repeat calibration and renew buffer solution;
replace electrode if necessary, check device
and measuring cable with simulator.
Yes No — —
1
E055
Below main parameter
measuring range
Check measurement and connections; check
device and measuring cable with simulator if
necessary.
Yes No No
E057
Main parameter measuring
range exceeded
Yes No No
E059
Below temperature measuring
range
Yes No No
E061
Temperature measuring range
exceeded
Yes No No
E063 Below current output range 1
Check configuration in the "Current outputs"
menu; check measurement and connections;
check device and measuring cable with
simulator if necessary.
Yes No No
E064 Current output range 1 exceeded Yes No No
E065 Below current output range 2 Yes No No
E066 Current output range 2 exceeded Yes No No
E067 Set point exceeded controller 1
Check configuration.
Yes No No
E068 Set point exceeded controller 2 Yes No No
E069 Set point exceeded controller 3 Yes No No
E070 Set point exceeded controller 4 Yes No No
E080 Current output 1 range too small
Increase range in "Current outputs" menu.
No No — —
1
E081 Current output 2 range too small No No — —
1
E085 Incorrect setting for error current
If the current range "0 ... 20 mA" was selected
in field O311, the error current "2.4 mA" may
not be set.
? ? ? ?
E100 Current simulation active No No — —
1
E101 Service function yes
Switch off service function or switch device off
and then on again.
No No — —
1
E102 Manual mode active No No — —
1
E106 Download yes Wait for download to finish. No No — —
1
E116 Download error Repeat download. No No — —
1
E147 Sensor communication faulty
Check that the sensor is correctly connected,
the cable ends are correctly wired at the
terminals and the cable is not damaged.
No No No
E152 PCS alarm Check sensor and connection. No No No
Error
no. Display Tests and/or remedial measures Alarm contact Error current Autom.
cleaning start
Facty User Facty User Facty User