Octopus RS, Руководство по установке

Страница: 20 / 24

OCTOPUS – Type RS Sailboat Drive
OC15276VL REV B.doc Subject to change without notice 20
C4: MECHANICAL CALIBRATION PROCEDURE
1. Disassemble the RFB
module from the drive housing,
by removing 2 attach screws.
2.
Complete the installation of the
drive unit into the vessel and
install the remote steering cable
following the drive installation
guide.
3.
Complete the electrical hook up
of the drive following the drive-autopilot installation guide.
4.
Complete the electrical hook up of the RFB
module following the drive-autopilot installation
guide.
5.
Center the gear on the RFB module by aligning the
red paint mark on the gear with the red paint mark
on the housing as shown in underside view graphic
below.
6.
By turning the steering wheel of the helm unit, centre the
rudder.
7. Reassemble the RFB module to the drive housing and
install and tighten the 2 attach screws. Ensure that the
mesh between the RFB module and the drive gear is not
excessive.
8. See autopilot installation guide for instructions on
additional software controlled RFB fine calibration and
HO limitation.
RFB MODULE
UNDERSIDE
VIEW
Align 2 red
dots vertically
COMPLETE
INSTALLATION