Oce VarioPrint 2045-65 NC, Руководство по эксплуатации

Страница: 131 / 213

The copy function 129
Stop or correct a copy job
Introduction
A copy job has the following phases (see ‘ Copy jobs in this manual ’ on
page 96 ).
1
The information of the originals is scanned, digitized and converted into an
image.
2
The images are printed.
3
The finisher collects the sets.
The table below depicts the actions to take if you need to stop or correct a
phase.
Note:
You can interrupt the print process before it has finished in order to start
a new job. The suspended job is continued after the new job is finished (see
‘Interrupting a copy job’ on page 131).
Correcting: When you define the copy job settings
Stopping: During the scanning process
If Then
You notice an incorrect setting for
the copy job Correct the copy job settings.
The scan process of a job or a job part
fails (phase 1) Stop the scanning process.
The printed sets are incorrect and the
job is not yet finished (phase 2 and 3) Stop the printing process.
If you press the correction key Then
Once The Océ VarioPrint 2045-65 NC re-
stores the default settings.
If you press the correction key Then
Once The Océ VarioPrint 2045-65 NC can-
cels the copy job.