Oce CS 5090, Руководство пользователя

Страница: 129 / 199

Error handling and troubleshooting 129
7
Check the belt for visible damage such as fraying and pieces coming apart.
8
Check the trailing cable (cable that moves during printer operation) for visible
damage.
9
Check whether the idler assembly (located at the left end of the belt) moves
freely. Check for cracks or damage.
10
After you’ve checked the above items, reboot the printer.
Note:
If the error re-occurs, observe whether the carriage is in the same or
different location.
Cannot draw ink during initial siphon
■
Check that the quick release fitting connection to the ink reservoir is secure.
■
Check whether contaminants have blocked the ink delivery lines. If
necessary, flush the lines with distilled water, then reprime.
Initial siphon cannot be established
■
Check that ink reservoirs are full.
■
Check the ink delivery system for leaks in the lines, at the tubing connection,
and at the quick connect coupling to the reservoir. If leaks cannot be stopped,
call Technical Support.
Ink cartridges do not fire properly
■
Clean cartridges and the service station periodically to maintain good print
quality (see ‘Clean the ink cartridge jet plate’ on page 107).
■
Cartridges wear out after extended use. Replace the cartridge.
■
Store cartridges in a sealed container at room temperature when not in use
for extended periods of time.
■
Make sure you have removed the protective tape from the cartridges.
■
Remove the cartridge and reinstall it, or clean the electrical contact on the
cartridge and carriage. Check that it is clean and dry, and properly installed
(see ‘Install ink cartridges’ on page 26).
■
Check that ink goes through the delivery lines. If necessary, use the Océ
Prime tool to force ink out of the nozzle plate and remove trapped air
bubbles.
■
Check that the ink reservoirs are filled.
Cartridges leak
■
Check that reservoirs are not overfilled.