Oce CS 5090, Руководство пользователя

Страница: 108 / 199

108 Océ CS 5090 User Manual
8
Press the ‘Prime’ button to check the cartridges. Repeat two more times, if
necessary. If the cartridges fire correctly, perform the appropriate calibration
procedures.
9
If the cartridge continues to misfire, remove the cartridge. Rinse the ink from
the bottom of the cartridge using warm distilled water. Note that removing the
cartridge too many times may create a large air bubble in the line, which could
lead to pen problems. Refill the lines with ink if necessary.
Note:
You can manually compensate for clogged jets.
10
Dry all surfaces of the cartridge, except for the jet plate area. Reinstall the
cartridge and reprime. Check the Prime test pattern and set the print mode as
indicated on the test pattern print. You may also want to run a colour test.
Clean the service station
Ink and dust can accumulate in the service station causing poor print quality.
Depending on how frequently you print, you may want to clean the service
station daily using the following procedure. We recommend that you replace
the service station about every six months or 2000 plot hours.
▼
To clean and inspect the service station
1
Select ‘Utility Menu’, ‘Access Menu’ then ‘Access Left’ or ‘Access Right’ to
move the carriage away from the service station.
2
Raise the printer cover.
3
Locate the service station release tab at the right end of the service station base.
Move it gently to the left and lift to remove the entire service station assembly.
4
Rinse the service station and wipers with warm water. Use cotton swabs to
clean small spaces.
5
Inspect the seals and wipers. Any damage to these parts can cause the cartridge
jetplate to clog, resulting in misfires.
!
! !
!
Click for Video