Oce Arizona T220, Руководство пользователя

Страница: 30 / 79

Océ | Media
3-20 3010100686-A
3.1.3
Media Holder Strips
Some media, such as Fome Cor, has a tendency to warp off the table when subjected to
heat. This warpage can result in a carriage collision. Media Holder Strips, which are
shipped with the printer, help to limit this possibility. Six strips are required to border the
long edges of a sheet of 4'x8' Fome Cor.
The media holder strips are 1/8" (3.2mm) thick. When using media with the media
holder strips, 3/16" (4.8mm) thick material should be used
Directions for use:
1. Place the media on the table with a minimum offset of 2"(50mm).
2. Turn on the vacuum.
3. Push the strips up against the long edges of the media, with the sharp edge protruding
into the middle part of the media. The strips will be held in place by the vacuum
holes underneath them.
Figure 10 Sheet of Foam Cor with 3 Media Hold-Down Strips
Figure 10 shows a sheet of 4'x8' Fome Cor on the printer table with 3 strips placed on
either side of the media.
Important:
Make sure you do not use any media less then this thickness.